做一个基于X86平台的小linux系统

使用2.4.20内核
去掉了模块化支持,所有东西全部编译成静态的.
网卡选了8139的. 拷了我Slackware下的rc.inet1,使之启动时运行
结果启动后总是出问题,如下:
kmod: failed to exec /sbin/modprobe -s -k net-pf-10, errno = 2
kmod: failed to exec /sbin/modprobe -s -k net-pf-3, errno = 2
kmod: failed to exec /sbin/modprobe -s -k net-pf-6, errno = 2
kmod: failed to exec /sbin/modprobe -s -k net-pf-4, errno = 2
kmod: failed to exec /sbin/modprobe -s -k net-pf-5, errno = 2
kmod: failed to exec /sbin/modprobe -s -k net-pf-9, errno = 2
kmod: failed to exec /sbin/modprobe -s -k net-pf-10, errno = 2
kmod: failed to exec /sbin/modprobe -s -k net-pf-3, errno = 2
kmod: failed to exec /sbin/modprobe -s -k net-pf-6, errno = 2
kmod: failed to exec /sbin/modprobe -s -k net-pf-4, errno = 2
kmod: failed to exec /sbin/modprobe -s -k net-pf-5, errno = 2
kmod: failed to exec /sbin/modprobe -s -k net-pf-9, errno = 2
kmod: failed to exec /sbin/modprobe -s -k eth0, errno = 2
kmod: failed to exec /sbin/modprobe -s -k eth0, errno = 2
kmod: failed to exec /sbin/modprobe -s -k eth0, errno = 2
kmod: failed to exec /sbin/modprobe -s -k eth0, errno = 2
我明明没有使用任何模块,还出现modprobe ,为什么呢?
(出错信息用dmesg获得,和源格式有点差别)

编译内核时少要了plip 重新编译后(网卡驱动继续编译进内核)
ifconfig ..................... 找不到网卡
SIOCADDRT: File exists
SIOCSIFADDR: No such device
eth0: unknown interface: No such device
SIOCSIFBRDADDR: No such device
eth0: unknown interface: No such device
SIOCSIFNETMASK: No such device
SIOCADDRT: Network is unreachable

奇怪了，在家里的一下就搞定了
看来还是在公司的那个内核配置文件有点问题